[Novalug] MTU settings
Joe Klein
jsklein@gmail.com
Mon Jul 27 16:10:57 EDT 2015
>From the fios help page:
"FiOS network requires an MTU of 1492 bytes."
My MTU database says, FIOS expected:
- Layer 2 network on the ONT is emulating a Ethernet v2 MTU (1500)
- Layer 2.5 routing is using PPPoE (Point-to-Point Protocol over Ethernet)
- PPPOE requires 8 octets
- Layer 3 IPv4 MTU would be 1492, unless you want fragmented packets.
Joe Klein
"Inveniam viam aut faciam"
On Sun, Jul 26, 2015 at 2:11 PM, Jon LaBadie via Novalug <
novalug@firemountain.net> wrote:
> To sync with Verizon's servers I've had to set the WAN
> interface on my router to an MTU of 1472 (was 1500).
> All other devices on the LAN are configured with an
> MTU of 1500.
>
> Would there be any effects, positive or negative, from
> setting all my systems interfaces to match the 1472 MTU
> of the internet side of the router?
>
> My guesses are:
>
> internet downloads, no effect as smaller packets are
> going to larger receptacles.
>
> internet uploads, possible benefit as large packets will
> not have to be split into two packets by the router.
>
> local lan traffic, tiny negative effect on large transfers
> as more packets are required.
>
> Thanks for any insights,
> Jon
> --
> Jon H. LaBadie novalugml@jgcomp.com
> 11226 South Shore Rd (703) 787-0688 (H)
> Reston, VA 20190 (703) 935-6720 (C)
> **********************************************************************
> The Novalug mailing list is hosted by firemountain.net.
>
> To unsubscribe or change delivery options:
> http://www.firemountain.net/mailman/listinfo/novalug
>
More information about the Novalug
mailing list